|
|
|
|
| 1. Using a hex type screw driver remove the
screws. |
2. Remove cable from terminal back plate of the speaker.
|
|
|
3. Remove tweeter by twisting counter |
4. Remove tweeter base by twisting it clock wise. counter clock wise.
If it is too tight, you may use a needle nose plier to loosen it. |
|
|
| 5. Carefully slide out the tweeter cables
|
6. Replace tweeter with voice coil cap. You from the speaker and out of
the tweeter base. can twist the cap on clock wise. Simply hand tightening
it., a tool is not necessary. |
|
|
| 7. Replace back plate cover. Be sure to first |
8. When finished the front of the speaker should place the tweeter terminal
covering the hole. Just show the bullet type voice coil cover. Before screwing
cover, align Audiopipe logo with the speaker terminal. |
|
|
|
|
|
|
|
|
| |
|
